Canon ELURA 50 Instruction Manual page 17

Only use videocassettes marked with the M_I_T logo.
1. Make sure that you have attached a power source.
2. Slide the OPEN / EJECT & switch to release the cassette
compartment cover.
• Pull the cover lully open (while holding the button) and wait a couple of
seconds tk_r the cassette compartment to open automatically.
• The confirmation beep sounds when the cassette cover fully opens.
3. Load or unload the cassette.
• Insert the cassette gently with the window facing outward and the
REC!SAVE tab to tile bottom.
• Remove The cassette by pulling it straight out.
4. Press the _ mark on the compartment until it clicks, and wait
for it to close.
5. Click the cover back into place.
[] Notes:
• Do not interfere with the cassette compartment while it is opening or closing
automatically, and do not attempt to close the cover until the cassette
compartment has fully retracted.
• Aider loading a cassette, use record search ( _ 38) to find the point where you
want to start recording.
• Be careful not to get your fingers caught in the cassette compartment cover.
• _1,1 flashes if no cassette is inserted when turning on the power (in TAPE
CAMERA and TAPE PLAY (VCR) mode).
• With some types of tapes, the remaining tape display may not give an accurate
reading ([._ 160).
gO .t
17