Wall Mounting - VTech t2419 Operating Instructions Manual

Your VT2418 Base Unit is designed to mount on a standard telephone wall
plate. Wall mounting is optional.
1. Choose a spot near an electrical outlet and a telephone jack.Your phone
requires a modular telephone jack and a standard electrical outlet (120V
AC). The power cord is six feet long; make sure there is an electrical outlet
within reach of the Base. The outlet should not be controlled by a wall switch.
If the switch is ever turned off, the phone will not operate.
2. Mount the base on the wall. Position the base so the mounting studs will fit
into the holes at the back of the Base. Position the power cord to extend down
the wall the phone is to be mounted on. Slide the Base down on the mounting
studs until it locks into place.
3. Connect the telephone cord. The telephone line cord has a snap-in plug at
each end. Insert one of the plugs into the jack on the bottom of the Base. Insert
the other end of the plug into the wall phone jack.
4. Connect the power cord. Plug the DC connector into the DC jack at the
bottom of the Base Unit. Plug the AC power adapter into an electrical outlet.

Wall Mounting

6