Table of Contents
Advertisement
Changing Channels
•
If you notice interference when using your
Handset, press CHAN to switch to a clear
channel. This function is only available when you
are on a call.
TONE/PULSE Setting
NOTE: Your VT 2418 is preset at the factory for
TONE dialing.
• If you have touch tone service on phone line:
• Press PROG, *, *, MEM to switch to TONE
dialing.
• If you have rotary service, press PROG, *, #,
MEM to switch to PULSE.
Temporary Tone
If you have a rotary (dial-pulse) telephone service,
(TONE/PULSE setting is set to PULSE), this
feature allows you to enter special codes and tones
to operate answering machines, use electronic
banking services, calling cards, or other special
services.
• Dial the call normally.
• Activate the Temporary Tone feature by pressing
TONE (the * key).
• You can then press the numbers or symbols you
need, and your phone will send the proper
signals.
• To end the call, press OFF or place the Handset
back in the Base. The phone will automatically
go back to rotary (dial-pulse) service.
Programming the Ringer Type
The Handset ringer is capable of four different
types of ringing tones. To select a different ringer
type do the following:
• Press PROG.
• Press the # key.
• Press a key 1 - 4 to select a ringer type.
• Press the MEM key to confirm.
NOTE: To program, the Handset must be OFF.
Turning Off the Ringer
To turn off the ringer on the Handset, do the
following:
• Press PROG.
• Press the # key.
• Press 5 to turn off the ringer. Press the MEM
key to confirm.
• To turn the ringer on again, see Programming
the Ringer Type.
Operating Instructions
10
Advertisement
Table of Contents
