Safety Information; Meaning Of The Safety Information; Pictograms And Symbols - Parkside PBH 1550 B2 Translation Of The Original Instructions

GB MT
–Concrete/brick ..............................32 mm
–metal ..............................................13 mm
Sound power level (L
...................................... 110 dB; K
Sound pressure level (L
....................................... 102 dB; K
Vibration Main handle
– (a ) .......... 17.754 m/s²; K=1.5 m/s²
h,HD
– (a ) ....... 18.830 m/s²; K=1.5 m/s²
h,CHeq
– (a ) .......... 19.286 m/s²; K=1.5 m/s²
h,CH
– (a ) ...........16.883 m/s²; K=1.5 m/s²
h,NL
Vibration Auxiliary handle
– (a ) .......... 22.942 m/s²; K=1.5 m/s²
h,HD
– (a ) ....... 21.898 m/s²; K=1.5 m/s²
h,CHeq
– (a ) .......... 23.750 m/s²; K=1.5 m/s²
h,CH
– (a ) ...........11.892 m/s²; K=1.5 m/s²
h,NL
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
total vibration value and the stated spe-
cified noise emission value can also be
used for a provisional assessment of the
load.
WARNING! The vibration and noise
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).
24
)
WA
=3 dB
WA
)
pA
=3 dB
pA

Safety information

This section deals with the basic safety in-
structions for using the device.
Meaning of the safety
information
DANGER! If you do not observe this
safety instruction, an accident will occur.
The result of which is severe bodily injury
or death.
WARNING! If you do not observe
this safety instruction, an accident may
occur. The result of which is likely severe
bodily injury or death.
CAUTION! If you do not observe this
safety instruction, an accident will occur.
The result of which is likely minor or mod-
erate bodily injury.
NOTICE! If you do not observe this safety
instruction, an accident will occur. The res-
ult of which is possible damage to prop-
erty.

Pictograms and symbols

Symbols on the device
Observe the operating instructions
Drilling
Impact drilling
Chiselling
Chisel position adjustment
Mains plug inserted (green LED
display)
Carbon brushes used up (red LED
display)