Maintenance - Chamberlain 98032 User Manual

Maintenance

Maintenance Schedule
EVERY MONTH
• Manually operate door. If it is unbalanced or binding, call
a trained door systems technician.
• Check to be sure door opens and closes fully. Adjust if
necessary, see page 16.
• Test the safety reversal system. Adjust if necessary, page
17.
EVERY YEAR
• Oil door rollers, bearings and hinges. The garage door
opener does not require additional lubrication. Do not
grease the door tracks.
• Test the battery backup and consider replacing the battery
to ensure the garage door opener will operate during an
electrical power outage.
Testing the Battery Backup:
1. Unplug the garage door opener from AC power. The
battery status LED will glow solid orange (opener is
operating on battery power) or will flash (low battery
power).
2. Open and close the door using the remote control or
door control.
3. In battery backup mode, the Automatic Garage Door
Lock will unlock when the garage door is opened, and
will remain disabled until power is restored.
4. Plug in the garage door opener. Verify the battery status
LED is blinking green (battery is charging).
myQ LED REMOTE LIGHT
• Unplug the light before cleaning.
• Use a lightly dampened cloth for cleaning.
• DO NOT use liquid cleaners on the light lens.
NOTICE: This device complies with Part 15 of the FCC rules and Industry Canada's license-exempt RSSs. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device must be installed to ensure a minimum 20 cm (8 in.) distance is maintained between users/bystanders and device.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules and Industry Canada
ICES standard. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
18
Replace the batteries
The Remote Control Battery with only 3V CR2016
coin cell batteries.
Dispose of old batteries
properly.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
Pry open the case first
• Replace ONLY with 3V CR2032 coin batteries.
in the middle (1), then
• DO NOT recharge, disassemble, heat above 212°F
at each side (2 and 3)
(100°C) or incinerate.
with visor clip.
Pry open the case first
in the middle (1), then
at each side (2 and 3)
with visor clip.
For the complete manual visit LiftMaster.com/Customer-Support
Remove screws (2)
Replace with
only 3V CR2032
coin cell battery.
Replace with
only 3V CR2032
coin cell battery.
3
1
2