Adjusting The Backlight; Adjusting The Color Mode; Adjusting The Color Theme; Enabling Screen Lock - Garmin GPSMAP 9 3 Series Owner's Manual

Adjusting the Backlight

1 Select > System > Sounds and Display > Backlight.
2 Adjust the backlight.
TIP: From any screen, press
the brightness is so low you cannot see the screen.

Adjusting the Color Mode

1 Select > System > Sounds and Display > Color Mode.
TIP: Select > Color Mode from any screen to access the color settings.
2 Select an option.

Adjusting the Color Theme

You can change the highlight and accent color used on most chartplotter screens.
1 Select > System > Sounds and Display > Color Theme.
2 Select an option.

Enabling Screen Lock

For anti-theft protection and to prevent unauthorized use of your device, you can enable the Screen Lock feature
which requires a PIN (Personal Identification Number). When enabled, you must enter the PIN to unlock the
screen each time you turn on the device. You can set up recovery questions and answers as prompts in case
you forget the PIN.
If you enable the Screen Lock feature, Garmin Support cannot retrieve the PIN or access your device. It is your
responsibility to provide the PIN to anyone authorized to use the vessel.
1 Select > System > Sounds and Display > Screen Lock > Setup.
2 Enter a memorable numeric PIN of 6 digits.
3 Reenter the PIN to verify.
4 When prompted, choose and answer three PIN recovery questions.
You can Disable or Reset the PIN and recovery questions as needed.

Turning On the Chartplotter Automatically

You can set the chartplotter to turn on automatically when the power is applied. Otherwise, you must turn on the
chartplotter by pressing
Select > System > Auto Power Up.
NOTE: When Auto Power Up is On, and the chartplotter is turned off using
reapplied within less than two minutes, you may need to press

Automatically Turning Off the System

You can set the chartplotter and the whole system to turn off automatically after it has been asleep for the
selected length of time. Otherwise, you must press and hold
1 Select > System > Auto Power Off.
2 Select an option.
Customizing the Chartplotter
repeatedly to scroll through the brightness levels. This can be helpful when
.
NOTICE
to restart the chartplotter.
to turn off the system manually.
, and power is removed and
11