Editing Parameters - Roland DDR-30 Owner's Manual

a. Editing Parameters
OPERATION
(1) Сай the drum sound you wish to edit by using
the instrument Button @ and the Patch
Number Button @.
@ Push the Edit Button {Voice ©, Pitch @,
GATE Ф or EQ (9) which includes the para-
meter to be edited.
The corresponding indicator will light up, and
now the DDR-30 is in the Edit mode. Meanwhile,
the Display shows the name ofthe first parameter
in the selected group, and its value.
(3) By using the Forward Button €) and the Back
Button Ф, call the parameter you wish to edit.
Е you wish to edit the first parameter in the
group, you can skip this procedure.
Pushing the Forward Button @ calls the next
parameter, and pushing the Back Button @ backs
one up.
@ Play the relevant pad, and edit the sound by
rotating the Alpha Dial.
The parameter value shown at the right of the
Display will change to a flashing number. This
means the parameter value is changed but not
yet written into memory.
(5) Е you wish to edit the parameters in this
group, repeat the procedures (3) and (2).
© When you have finished editing, push the
same Edit Button you pushed in the proce-
dure ©.
The Edit mode is now cancelled. At the right of
the Display, the patch number of the drum sound
you have just edited will flash.
*|f you wish to edit the parameters of other
group, go back to the step (2).
NOTE
This editing operation does not automatically
rewrite the existing drum sound. To write the
edited sound into memory, take the following
Writing operation.
13