Roland DDR-30 Owner's Manual page 16

EQUALIZER GROUP
The parameters in this group can adjust
the tone of each voice.
Treble
TOC Th г E Ы Г А ce
ЕГИ LLL
corvo
This parameter cuts or boosts higher fre-
I quencies. At "O", flat characteristic is
obtained (towards +6: boosted, —6: cut).
Bass
"CIC. c с К кр
An 173 ри
mto
2 This parameter cuts or boosts lower fre-
quencies. At "O", flat characteristic is
obtained (towards +6: boosted, —6: cut).
GATE GROUP
Gate Level 1
"m
Ср d п-99
ier
ит 1
са
! г
БОС
This parameter sets the volume needed to
obtain the Gate 1 effect. At 0, no effect is
obtained, and "99" is the maximum
volume.
Gate Time
г ТТА л noo
Lt
1111 L
7221
GATE GROUP
The parameters (Gate 1 and 2) in this
group can create signal gate effect that is
a sudden cut of a sound.
Gate 1
The gate effect can be obtained only
when the pad is hit harder than a certain
level. Also, the sound can be sustained as
long as you like.
Gate 2
The gate effect can be obtained in what-
ever manner you play the pads. Unlike
Gate 1, the sound cannot be sustained.
This sets how long the sound should be
sustained. The volume of the sustained
sound is what set with the Gate Level 1.
Gate Release 1
This sets the time needed for the Gate 1
sound to finally fade out.
Gate Level 2
This sets the level at which the Gate 2
effect begins. The value should represent
the percentage to the initial level.
Gate Release 2
5 1 D HOERHOE 1-33
This sets the time needed for the Gate 2
sound to finally fade out.
16