Table of Contents
Advertisement
O P E R AT I O N
CHASE MODE
This unit can be used as a 4 channel chaser when it has been set to 4 channel output. This
function allows you to select any of these 16 built-in programs or set the pack to chase as
desired to get a more dramatic light show. You may control the speed at which the programs
will chase.
Chase Enable:
Tap MODE until the Chase LED is shown in the display screen, indicating that Chase mode is
active.
Chase Program:
1. When the device is in Chase mode, the display screen shows the chase program.
• "Pr" followed by two numbers or "AU": any program selected will chase instantly.
• "PF" followed by two numbers or "AU": any program selected will fade or glide
between chase steps instead of instantly changing. The rate of the change is adjusted
by the time between steps (chase speed).
• "AU": in either case, this indicates that each of the 16 programs will be executed
eight times in sequence.
2. Tap UP/DOWN to select from 1-16 programs.
Chase Effect:
1. When the device is in Chase Mode, tap MENU until Chase Effect is activated.
2. Tap UP/DOWN to change between Pr and PF.
NOTE: When this unit is set to function as a switch pack, the programs will chase without
fade-in or fade-out. Programs can only be set to fade in or out when this unit operates as a
dimmer pack.
Chase Speed:
1. When the device is in Chase mode, tap the Menu button until the display screen shows
"SP" followed by two numbers.
2. Tap UP/DOWN to select desired chasing speed. 01 is the slowest speed, and 99 is the
fastest speed.
Remote Type:
1. When the device is in Chase mode, tap MENU until the display screen shows "FOOT" or
"RF".
2. Tap UP/DOWN to change between FOOT and RF modes.
• If FOOT is selected, a foot control (sold separately) is used to control this unit.
• If RF is selected, a detector and a RF control (sold separately) are required to control
this unit.
Follow the directions below to use RF control:
1. Turn off the unit's power.
2. While pressing MODE, apply power to this unit.
3. Tap any button on the RF control within five seconds of powering on the unit. The RF
control will now be paired to this unit.
4. Repeat steps 1-2 to deselect the RF control.
17
Advertisement
Table of Contents
