Service & Lubrication Information - Snapper SPLH152KW, SPLH172KW, SPA361, SPA481, SPA521, SPA611 Safety Instructions & Operator's Manual

SECTION 4 - SERVICE & LUBRICATION INFORMATION
TRACTION LEVERS
Lubricate each with 1-2 shots of
grease every 25 hours of operation.
INTERLOCK SWITCHES
Inspect switches for ease
of operation.
HYDRAULIC OIL
Use SAE 10W-30 Oil.
HYDRAULIC FILTER
Change Hydraulic Oil and Filter
after first 25 hours of operation.
Thereafter, change Hydraulic Oil
and Filter every 200 hours
(monthly).
MOTOR HUBS - Lubricate
Motor Hubs with Anti-Seize
Compound when replacing
Wheel Hubs.
DEFLECTOR
Lubricate hinge
points as required.
HYDRAULIC HOSES & FITTINGS
Check daily for leaks, cracks,
kinks, and other signs of wear.
MOWING DECK
At end of each mowing period,
remove grass and debris from
under mowing deck and above
rear SAFETY Shield.
CONTROLS & LINKAGES
Before each mowing period, coat all wear
points, hinge points and sliding parts with
medium duty oil.
FRONT TIRES
Check tire pressure before
each mowing period. Inflate to
25 PSI.
FIGURE 4.1
19
IN-LINE FUEL FILTER
(Not Illustrated)
Replace every 100
ENGINE
Change Oil Filter after first 5 hours of
operation. Change engine oil every 25
hours under normal conditions or daily
under extreme dusty conditions. Change
Filter every 50 hours of operation.
Clean AIR FILTER Foam Element
every 25 hours. Service PAPER
ELEMENT every 100 hours.
REAR TIRES - Check tire
pressure before each mowing
period. Inflate to 12-15 psi.
CUTTER SHAFT
SPINDLES
Lubricate each with two
(2) SHOTS of bearing
grease daily.
CUTTER DECK
BELT(S)
Check for cracks or
wear.
FRONT WHEEL BUSHINGS
& CASTER SHAFTS
Lubricate with bearing grease
weekly.
MOWER BLADES
Check for tightness every 25
hours of operation. Tighten
capscrews to 75 foot pounds.