Table of Contents
Advertisement
Look for the oven model and Wi-Fi
Module Software version on http://
electrolux.opensoftwarerepository.com
inside "NIUX" folder.
5.3 First connection to the
mains
When you connect the oven to the mains
you have to set the language, the time,
the clock format, the date, the fast heat-
up, the water hardness level .
Water hardness
Class
dH
1
0 - 7
2
7 - 14
3
14 - 21
4
over 21
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the 4 colour change strip
supplied with the steam set in the
oven.
2. Put all the reaction zones of the strip
into the water for approximately 1
second.
Do not put the strip into the running
water.
3. Shake the strip to remove the excess
of the water.
4. Wait 1 minute and check the water
hardness with the table below.
The colours of the reaction zones
continue to change. Do not check the
water hardness later than 1 minute
after test.
5. Set the water hardness: menu: Basic
Settings.
Test strip
Calcium deposit
(mmol/l)
0 - 1.3
1.3 - 2.5
2.5 - 3.8
over 3.8
Water hardness
1
Select the values and press OK to
confirm. You can change the settings in
the menu: Basic Settings.
5.4 Setting the water hardness
The table below shows the water
hardness range (dH) with the
corresponding Calcium deposit and the
quality of the water.
Calcium deposit
(mg/l)
0 - 50
50 - 100
100 - 150
over 150
Test strip
You can change the water hardness in
the menu: Basic Settings / Water
hardness.
5.5 Wireless connection
To connect the oven you need:
• Wireless network with Internet
connection.
• Mobile device connected to your
wireless network.
1. Turn on the oven.
2. Choose wireless network with
Internet connection.
3. Press YES to confirm.
Oven wireless module will start after 1
minute. To configure the wireless
connection at any other time press
the display.
ENGLISH
11
Water clas‐
sification
Soft
Moderately
hard
Hard
Very hard
Water hardness
2
3
4
on
Advertisement
Table of Contents
