Adjusting The Turf-Compensation Spring - Toro Reelmaster 5610-D Operator's Manual

Adjusting the Lift-Arm Turnaround Position (continued)
3. Loosen the jam nut that secures lift-arm switch
to the switch plate
4. Adjust the lift-arm switch as follows:
• To increase the lift-arm turnaround height,
move the switch down.
• To decrease the lift-arm turnaround height,
move the switch up.
Maintain an air gap of 1.0 to 2.5 mm (0.040 to 0.100 inches) between the switch and
the lift-arm trigger. The LED light on the switch verifies proper function of the switch.
5. Torque the jam nuts to 20 +/- 2 N∙m (15 +/- 1.5 ft-lb).
Do not overtorque the jam nuts; otherwise, you may damage the sensor.

Adjusting the Turf-Compensation Spring

The turf-compensation spring transfers the weight from the front roller to the rear roller. This
helps to reduce a wave pattern in the turf, also known as marcelling or bobbing.
Make spring adjustments with the cutting unit mounted to the traction unit, pointing
straight ahead and lowered to the ground.
1. Make sure that the hairpin
rear hole in the spring rod
Note:
the hairpin to the spring-rod hole next to the
turf-compensation spring
2. Tighten the hex nuts
spring rod until the compressed length of the
spring is 15.9 cm (6.25 inches).
3464-493A
.
When servicing the cutting unit, move
on the front end of the
IMPORTANT
IMPORTANT
IMPORTANT
is installed in the
.
.
Page 5–19
G439054
G402845
Operation: During Operation