Diagnostics; Entering Diagnostics - Fisher & Paykel DishDrawer DD60 Series Service Manual

6.1 Entering Diagnostics

1
To enter diagnostics, open the tub and wait until the user flange display turns off, this will take approx.
30 seconds. Press and hold the START and >>CYCLE button for 5 seconds, the START button must be
touched first.
(note: the flange touch buttons operate on button release, not on initial touch). T
and hold the START button.
2
When first entering the diagnostics mode, the display sub mode (dP) is initially activated as the first sub
menu. This is indicated by the EXTRA DRY & qUICk wash modifier LED's being lit.
3
Press the START button to enter the sub mode, and all the lights will illuminate and stay lit (display
menu 1), Press START button again to view the most recent fault on the flange display. Press the START
button again to view the previous fault display, and to highlight the previous fault the delay indicator
LED will be illuminated (display menu 2)
4
To clear the fault codes, touch the >> CYCLE button for 2 seconds.
5
To scroll to the next sub menu (HO) touch the >>CYCLE button.
Hardware Output Mode (HO)
1
Once in hardware output mode, the EXTRA DRY & SANITIZE wash modifiers will be lit.
2
Press the >>START button to enter the sub mode.
3
The >> CYCLE button will scoll through the outputs which are highlighted on the following page.
4
The hidden WiFi LED will illuminate red to show the output is on if selected.

6 DIAGNOSTICS

Display diagnostic
DISPLAY MENU 1
DISPLAY MENU 2
DISPLAY MENU 3
o exit at any time press
Press and hold >> and
START. Start must be
pressed first
>> scrolls through the
diagnostics sub menus
Start toggles the mode
All lights on,
Fault codes. Two entry
fault stack, refer to binary
fault. Illuminated delayed
start LED refers to oldest
of the two.
Start scrolls through.
Press and hold >> and
* simultaneously
Start scrolls through and
clears faults.
Step through to
hardware output.
41