Component Testing - Fisher & Paykel DishDrawer DD60 Series Service Manual

7.3 Component Testing

Motor Controller
(Back View)
Connector
Motor Controller
(pin numbers on the connectors go from Top to Bottom)
P101 Power
P201 Bottom tub motor phases
Bottom tub element
P202 Top tub motor phases
Top tub element
P203 Bottom tub fill valve
Bottom tub lid motors
P204 Top tub fill valve
Top tub lid motors
Wash Controller
(pin numbers on the connectors go from Right to Left)
P401 Power
P402 Temperature sensor
P405 Rinse aid coil
Drying fan
detergent diverter
P407 water softener bypass valve
Water softener brine pump
7 FAULT DIAGNOSTICS
Device
1&2,2&3,
1&2,2&3,
Note: motor controller is situated
on the inside rear chassis panel
behind bottom tub
P404 P406 P407
Pins
1-2 240 Vac AU, NZ, SG, PF
120 Vac US, TW
8.0 ± 5 Ω (per winding) 16 Ω phase to phase
1&3
4-5 55-60 ± 3 Ω AU, NZ, SG, PF
24-27 ± 3 Ω US,TW
8.0 ± 5 Ω (per winding) 16 Ω phase to phase
1&3
4-5 50 ± 3 Ω AU, NZ, SG, PF
24-27 ± 3 Ω US,TW
1-2 65 ± 10 Ω
3-6 Check between pin 3 & 4, 5 & 6 if open or short circuit
1-2 65 ± 10 Ω
3-6 Check between pin 3 & 4, 5 & 6 if open or short circuit
1-2 24+-5V
1-2 12000 Ω @ 20
8300 Ω @ 30
3000 Ω @ 60
1-2 65 ± 10Ω
5-6 Check if open or short circuit
Note: Run in diagnostics and check fan torque
7-8 65 ± 10Ω
1-2 65 ± 10Ω
(only used on water softener models)
3-4 65 ± 10Ω
(only used on water softener models)
Wash Controller
(Front View)
P402 P410 P403
Description
68 F)
C (
o o
86 F)
C (
o o
140 F)
C (
o o
P405 P401 P408
57