Table of Contents
Advertisement
4-7-7.
MB-1217 Board
Preparation
1.
Refer to
"4-2. Flow
Chart".
Procedure
1.
Remove the four screws to detach the rear frame L assembly.
2.
Disconnect the harnesses from the two connectors (CN907, CN908) on the MB-1217 board.
CN907 (MB-1217 board)
Wire holder
Harness (Black)
Note
When installing the two harnesses, arrange the two harnesses as shown in the figure.
3.
Disconnect the harness from the connector (CN901) on the MB-1217 board.
4.
Disconnect the harnesses from the two connectors (CN902, CN903) on the MB-1217 board.
5.
Remove the three screws to detach the MB plate.
PWS-4500
CN908
(MB-1217 board)
Harness (Red)
PSW3 x 6
PSW
3 x 6
Rear frame L assembly
4-37
Advertisement
Table of Contents
