Energy Pulsing; Default Energy Pulsing Led Sources - Siemens US2:9810T24V User Manual

Inputs/Outputs
Parameter
Source
Force ON
Force OFF*
Normal*
EventLog Mode Log Off/Log On
Polarity
PulseWidth
Port
* These parameters are only valid when pulse width is set to 0.

Energy pulsing

You can configure the meter's energy pulsing LEDs or onboard digital outputs for energy pulsing
applications.
When an LED or output is set to energy pulsing, the meter sends a readable pulse or signal based
on the measured energy source value. This pulse can be used for accuracy verification or as an
input to another energy monitoring system.

Default energy pulsing LED sources

Your meter's energy pulsing LEDs have default energy source values configured for accuracy
verification testing.
For LED locations, see your meter's installation guide.
Calibration Pulser LED
WATT LED
VAR LED
143
Value/Range Description
Link this input to the value that drives the state of the
digital output.
Digital/Boolean
If Source is not linked, the digital output state is driven by
the Force ON, Force OFF values.
Link this input to a pulse that forces the digital output on
Pulse for the PulseWidth duration, regardless of the Source
input.
Pulse Link this input to a pulse that forces the digital output off.
Pulsing this input will switch the driver of the digital output
Pulse
from Force ON to Source.
Specifies if events generate log entries.
Inverting/non- Specifies if the signal to the digital port is inverted or not
inverting inverted.
Specifies the duration of the pulse, in seconds.
0–2,000,000
Setting this parameter to 0 sets the digital output
continuously on.
The physical digital output port connection. Only available
-
ports are shown.
LED
kWh pulse LED
kWh pulse infrared LED
kVARh pulse LED
kVARh pulse infrared LED
9810 series - User manual
Default energy pulsing source
kW del-rec
kVAR del-rec
7EN05-0390-08