Baffle Removal - Quadra-Fire 43ST-ACC-AU Owner's Manual

D. Baffle Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. The baffle board has 2 pieces. With the ceramic blanket
still in place, slide one baffle piece over the top of other
one and pull out top piece through the door opening and
then remove bottom baffle piece (Figure 22.1).
3. Remove the ceramic blanket.
4. Re-install the baffle pieces one piece at a time. Be sure
the baffle boards are even with the front manifold tube and
is resting on all tubes (Figure 22.3).
5. To re-install the ceramic blanket, it is easier to fold it in
half first. Place on top of baffle board, open up and flatten
and smooth out the blanket. Re-check the baffle board for
correct positioning (Figure 22.2 & 22.4).
Figure 22.1 - Baffle
Figure 22.2 - Ceramic Blanket
22
Baffle Board even with front tube & resting
Figure 22.3
Ceramic Blanket on Top
Tube Channels
Figure 22.4
7037-807C
on all tubes
Burn Rate
Air Control
Start-Up Air
2 pc Baffle Board
Control
02/23