Table of Contents
Advertisement
Adjusting the TV
Adjust your TV receiver to receive the signal from your
recorder.
When you have connected a color monitor or a TV
equipped with video/audio input jacks, the following
adjustment is not necessary.
Rear
RF UNIT
1 Set RF UNIT located at the rear to 3 CH or 4 CH,
whichever channel is not active in your area.
2 Press POWER. The indicator will light up.
3 Insert a recorded cassette.
4 Press » PLAY.
5 Turn on the TV.
6 Set the TV receiver to either VHF channel 3 or 4 to
agree with the RF UNIT setting.
lf the recording on the tape is clearly displayed on the TV
screen
The TV adjustment is complete.
If a picture does not appear or if the display is not clear
Fine-tune the channel (3 or 4) on the TV.
Whenever you use the video recorder, you should set
the TV to the channel which you have chosen above.
38
Advertisement
Table of Contents
