Table of Contents
Advertisement
Antenna/Cable and TV Connections
UHF antenna
VHF/UHF
IN
VHF/UHF
OUT
Antenna connector (supplied)
When separate VHF and UHF antennas are connected
t,
300-ohm
ribbon type lead-in
EAC-66
U/V band
separator
75-ohm coaxial cable (supplied)
Connect the wire
and tighten
the screws.
F-type connector
(optional)
(mixer)
U/V band separator
Caution
Connections between the recorder VHF/UHF OUT
connector and the antenna terminals of a TV receiver
should be made only as shown in these instructions.
Failure to do so may result in operation that violates the
regulations of the Federal Communications Commission
regarding the use and operation of rf devices.
Never connect the output of the recorder to an antenna
or make simultaneous (parallel) antenna and recorder
connections at the antenna terminals of your receiver.
34
75-ohm coaxial cable (supplied)
When a TV has a 75-ohm UHF/VHF antenna terminal
Easy connection of the recorder to the TV can be made
with the supplied 75-ohm coaxial cable regardless of the
types of antenna.
Once the connections explained above have been made,
the antenna TV signals, as well as the signal from the
recorder, will be fed to the TV and you can watch TV
programs in the usual way.
Advertisement
Table of Contents
