Table of Contents
Advertisement
Parameter Variation Range for LCL.MIDI Block
Parameter variation range for input/output blocks
[ aonen
Parameters
hes
et
range
ee
level
0% — Set value
phase
control change data = normal if 0 - 63
= inverse if 64 - 127
panpot
0% -— Set value
panpot limit min
Set value - set value for panpot limit max (*4)
panpot limit max
Set value for panpot limit min - set value (*5)
If the contro! by LCL.MIDI exceeds the upper limit of a
parameter, the upper limit value is used. On the contrary, the
lower limit value is used if it exceeds the lower limit.
(*1) Reverberation time has a different resolution according
to the algorithm and the parameter value as shown
below. Therefore, available time range differs for the set
value even in controlling with LCL. MIDI.
HLR,PLR-
0.1sec step if 0.3sec — 10.0sec
1.0sec step if 10.0sec - 99.0sec
RMR
0.04sec step if 0.12 - 4.00sec
0.4sec step if 4.00 - 39.60sec
For example, when the algorithm is HLR and the set
value is 10.0sec, the available time range lies between
set value —6.4sec and set value
+ 63sec.
(*2) "size" and "spread" have a different range available
according to the algorithm used.
5 6
APPENDIX B
0-500
ms
1
msstep
500 ms - 1000 ms
10
ms step
1000 ms ~ 5000 ms
100 ms step
(*5) In case you change the panpot limit max using LCL.
MIDI so that panpot is equal to or larger than panpot
limit max, panpot is also changed to the value of panpot
limit max.
3
Advertisement
Table of Contents
