Fitting The Accessories - Moulinex DFC611BA Manual

- Using the upper drive (a2): check that no accessories are attached to the lower drive.
THE FUNCTIONS OF YOUR FOOD PROCESSOR
1 ASSEMBLING THE REMOVABLE PARTS
- Fitting / removing the bowl (b3)
The bowl is used with the following accessories (depending on model):
- Cutters (e), vegetable cutters (d), whisk (f), emulsifier (g), citrus press (h), centrifugal
juice extractor with filter basket (m5) "Maxipress" (l).
- If it is not already fitted, fit the seal (b3-2) onto the bottom of the bowl.The lip of the seal
must be facing upwards.
- Fit the drive rod (b3-1) onto the seal (b3-2).
- Lock the assembly with the nut (b3-3) until it locks.
- Dismantle the assembly and clean it after each use.
- Fitting / removing the handles (b4) of the bowl and (k4) the blender.
- For easier cleaning and storage, the handle of the bowl (b4) and the blender (k4) can be
removed.
- To fit the handle, position it opposite the clips of the bowl.
- Slide the handle upwards until it clicks into place.
- To remove the handle, press the release knob (b4-1) or (k4-1) and slide it downwards.
(Note: the lid of the blender must be removed to allow the handle (k4) to be taken off.
The handle (b4) must be fitted to the bowl so that the upper drive cover (a1) may be
locked.
2 MIXING / BLENDING / MINCING / KNEADING
ACCESSORIES USED (depending on model)
- Bowl assembly (b), spindle (c), and cutters (e):
• metal blade (e1) for blending and chopping.
• plastic kneader (e2) for kneading or mixing.

FITTING THE ACCESSORIES

Press the release button (a4) to open the upper drive (a1) cover.
- Place the bowl (b3) on the lower drive (a3).
- Place the spindle (c) on the bowl drive (b3-1).
- Slide the metal blade (e1) or the plastic kneader (e2) onto the spindle (c), to the bottom
of the bowl.
- Place the ingredients in the bowl.
- Fit the lid (b2) onto the bowl.
- Close the upper drive cover (a1).
You should hear it "click" shut.
To release the cutters (e) from the spindle (c):
- Place the assembly on a stable surface.
- Turn the spindle (c) in a clockwise direction while holding the cutter (e) at the top.
15 15