Polaris Patriot 650 2024 Owner's Manual page 202

DIAGNOSTIC TROUBLE CODES (DTC)
DIAGNOSTIC TROUBLE CODES (DTCS) – MATRYX
SPN = SUSPECT PARAMETER NUMBER / FMI = FAILURE MODE INDICATOR
TROUBLE CODE
Exhaust
Temperature
Sensor 2 Abnormal
Rate of Change
Exhaust
Temperature
Sensor 2 Mismatch
with Sensor 1
ECU Supply
Voltage High
ECU Supply
Voltage Low
Critical Supply
Voltage High
Critical Supply
Voltage Low
Chassis Supply
Voltage High
Chassis Supply
Voltage Low
Peak Injector
Voltage High
Peak Injector
Voltage Low
200
SPN FMI
520173 10
520173 14
520174 3
520174 4
520175 3
520175 4
520176 3
520176 4
520177 3
520177 4
P-COD-
E
P1486 This Trouble Code sets if the Exhaust
Temperature Sensor Signal changes too
quickly to be considered a Realistic Value.
Can be caused by Damaged Wiring, a
faulty Exhaust Temperature Sensor or
ECU / Connections.
P1488 This Trouble Code Sets when Exhaust
Temperature Sensor 2 signal is 250C
greater than Exhaust Temp Sensor 1
signal. The condition can be caused by
Damaged Wiring, faulty Exhaust
Temperature Sensor or ECU /
Connections.
P1341 This Trouble Code sets if the ECU Supply
Voltage is above 17.00V. Can be based by
faulty wiring, faulty regulator or ECU /
Connections
P1342 This Trouble Code sets if the ECU Supply
Voltage is below 10.00V. Can be based by
faulty wiring, faulty regulator or ECU /
Connections.
P1343 This Trouble Code sets if the Critical
Supply Voltage is above 17.00V. Can be
based by faulty wiring, faulty regulator or
ECU / Connections.
P1344 This Trouble Code sets if the Critical
Supply Voltage is below 10.00V. Can be
cbased by faulty wiring, faulty regulator or
ECU / Connections.
P1345 This Trouble Code sets if the Chassis
Supply Voltage is above 18.00V. Can be
based by faulty wiring, faulty regulator or
ECU / Connections.
P1346 This Trouble Code sets if the Chasssis
Supply Voltage is below 14.00V. Can be
based by faulty wiring, faulty regulator or
ECU / Connections.
P1347 This Trouble Code sets if the Peak Injector
Supply Voltage is above 24.00V. Can be
based by faulty wiring, faulty regulator or
ECU / Connections.
P1348 This Trouble Code sets if the Peak Injector
Supply Voltage is below 20.00V. Can be
based by faulty wiring, faulty regulator or
ECU / Connections.
CONDITION