Table of Contents
Advertisement
VEHICLE CONTROL SYSTEM
The vehicle control system on your vehicle helps to limit excessive operational
temperatures of the vehicle brake system. If the brake and throttle system are
operated at the same time and either of the following conditions are triggered,
check the brake system to ensure that there are no obstructions that would
prevent the lever from moving freely and returning to its disengaged position.
The two step warning and performance reduction sequence will engage when
the following conditions are met:
Step One–
• The engine speed is above 4500 RPM
• The brake is engaged
• The throttle is engaged
After 4 consecutive seconds, the power output from the engine will be
decreased. A warning message will also appear on your display. To clear the
display message and regain full power, restart the vehicle.
Step Two–
• The engine speed is above 2500 RPM
• The brake is engaged
• The throttle is engaged
After 15 consecutive seconds, the vehicle will shut down. If shutdown occurs,
check the brake system to ensure the parking brake is not engaged.
POLARIS ELECTRONIC REVERSE CONTROL
(PERC)
Improper reverse operation, even at low speeds, may cause loss of control,
resulting in serious injury or death. Damage will occur to the chaincase or
transmission if shifting is attempted when the engine is operating above idle
• Shift to or from reverse only when the snowmobile is stopped and when
engine speed is at idle.
• Look behind the vehicle before and while backing.
• Avoid sharp turns.
• Apply throttle slowly.
Electronic reverse will activate only if the engine RPM is below 3000.
WARNING
speed.
OPERATION
129
Advertisement
Table of Contents
