Cleaning And Care - Vitek VT-1360 Manual Instruction

Step two
Switch the hair clipper off with the button (4) by pressing
it once, install the attachment comb for longer hair (7) or
(8), switch the clipper on and continue cutting hair near
top of the head (pic. 3, 4).
Step three – cutting in the temples area
Switch the hair clipper off with the button (4) by pressing
it once, install the attachment comb (5) or (6) and cut
hair in the area of temples. Then install the attachment
comb (7) or (8) and continue cutting towards the top
of the head.
Step four – cutting the crown of the head Using the
attachment comb (7, 8) cut the hair from the top of the
head towards the crown against the hair growth direction.
– You can cut hair against and along the direction of hair
growth, but keep in mind that the hair cut against the
growth will be shorter than the hair cut along the growth.
– Use the attachments (5) or (6) for very short cutting.
To leave a little longer hair, use the attachments (7, 8).
– To leave longer hair, take hair locks between your fin-
gers and cut hair using the hair clipper.
– You may use a comb: lift the hair locks and cut them
with the hair clipper above the comb (pic. 6).
– Always start cutting from the head back.
– Comb the hair to reveal uneven locks.
– Use scissors to trim hair.
Step five – the final part
In the final stage of hair cutting remove the attachment
comb from the unit, turn the blades (1) of the clipper
towards the hair and trim hair on the temples and neck
carefully (pic. 7). Do not press the clipper strongly, there
is danger of injuries or cuts when open blades (1) come
in contact with skin.

CLEANING AND CARE

Lubricating the blades
Lubricate the blades (1) before and after every use of the
hair clipper with the oil (10) supplied with the unit.
– Switch the clipper off with the on/off button (4) and
unplug it.
ENGLISH
21