Sharp InGlass PN-LA862 Operation Manual page 38

Menu Items
(6) BRIGHT
Sets the brightness when changing the screen brightness
at a specified time. When "AMBIENT LIGHT SENSING" is
enabled, "AMBIENT LIGHT SENSING" has priority. (See
page 29.)
Caution
• Do not switch off the main power after setting the
"SCHEDULE".
• Specify the correct date and time. (See page 32.)
"SCHEDULE" does not function unless the date and time
are specified.
• Check regularly that the set date and time are correct.
• When a temperature abnormality occurs and the backlight
brightness is reduced, the brightness is not changed even
if a schedule set to "BRIGHT" is executed.
TIPS
• Up to 8 SCHEDULE items can be registered.
• A SCHEDULE that has a large number has precedence
over that of a small number when schedules overlap.
38
E
nAbout remote control numbers
If there is another monitor nearby, you can change the remote
control number to prevent the other monitor from being
operated by the remote control unit.
Set the same number in the monitor and in the remote control
unit.
TIPS
• You can set remote control numbers to values from 0 to 9.
• When the remote control unit batteries become exhausted
and when you replace the batteries, the number on the
remote control unit may be reset to 0.
Changing the remote control number on the monitor
Use "REMOTE No." on the ADMIN menu to set the number.
(See page 32.)
1. Use the or button to select the remote control
number.
2. Select ON and press the ENTER button.
The remote control number is set on the monitor.
Changing the remote control number on the remote
control unit
1. While holding down the ID SET button, hold down the
number that corresponds to the remote control number
set on the monitor for 5 seconds or more, and then
release these buttons.
The remote control number is set on the remote control unit.
Checking the remote controller number
* Perform these steps on the remote control unit.
1. Press the INFORMATION button to display
"INFORMATION1".
2. Check that "REMOTE No." is the remote control
number that you have set in the above procedure.
3. Press the RETURN button to close the monitor
"INFORMATION" screen.
TIPS
• If the remote control numbers on the monitor and remote
control unit are different, they will both be displayed on
"INFORMATION1". On this screen, you can press the
ENTER button to match the number on the monitor with the
number on the remote control unit.
• Even if the remote control numbers are different, you can
use the remote control unit to display the "INFORMATION"
screen.