Cleaning The Glass Ceramic Sheet; Care Of Plated Parts; Replacements - Spartherm ZERO CLEARANCE FIREPLACE-700 Installation And Operating Instructions Manual

If it is necessary to clean the glass, buff lightly with a
clean dry cloth and non-abrasive cleaner.
DO NOT CLEAN GLASS WHEN HOT! Clean the glass
after the first 10 hours of operation with a suitable
stove glass cleaner. Thereafter clean as required.
The glass is very strong but do not let burning fuel
rest or fall against it and always close the door gently.
NEVER FORCE IT SHUT!
If the glass should ever crack or break while the fire is
burning, do not open the door until the fire is out and
do not operate the appliance again until the glass has
been replaced, available from your authorized dealer.
DO NOT USE SUBSTITUTE MATERIALS.
6.7 CLEANING THE GLASS CERAMIC
SHEET
WARNING
THE GLASS CERAMIC SHEET MAY ONLY BE CLEANED
WHEN COLD (wood insert NOT BURNING AND COOLED
DOWN; NO HOT ASH IN THE FIRE CHAMBER).
WARNING
All Spartherm inserts are supplied with Robax glass
in the door.
Robax is a ceramic glass.
Do not use substitute glass and order replacement
glass from Spartherm through your dealer.

6.8 CARE OF PLATED PARTS

If the appliance is equipped with plated parts, you
must clean fingerprints or other marks from the plated
surfaces before operating the appliance for the first
time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the first
time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fingerprints
and oils will not affect the finish and little maintenance
is required, just wipe clean as needed. Prolonged high
temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best
removed when the assembly is at room temperature
but this can be improved if the assembly is warmed,
using a hair dryer or similar heat source.

7. REPLACEMENTS

Contact your dealer or the factory for questions con-
cerning prices and policies on replacement parts. Nor-
mally all parts can be ordered through your authorized
dealer / distributor. FOR WARRANTY REPLACEMENT
PARTS, A PHOTOCOPY OF THE ORIGINAL INVOICE
WILL BE REQUIRED TO HONOUR THE CLAIM. When
ordering replacement parts always give the following
information:
• Model & Serial Number of appliance
• Installation date of appliance
• Part number
• Description of part
• Finish
IDENTIFIES ITEMS WHICH ARE NOT ILLUSTRATED. FOR
FURTHER INFORMATION, CONTACT YOUR AUTHORIZED
DEALER.
WARNING
FAILURE TO POSITION THE PARTS IN ACCORDANCE
WITH THIS MANUAL OR FAILURE TO USE ONLY
PARTS SPECIFICALLY APPROVED WITH THIS
APPLIANCE MAY RESULT IN PROPERTY DAMAGE
OR PERSONAL INJURY.
24