Spartherm ZERO CLEARANCE FIREPLACE Installation And Operating Instructions Manual
Hide thumbs
Also See for ZERO CLEARANCE FIREPLACE:
- Installation and operating instructions manual (28 pages) ,
- Installation and operating instructions manual (28 pages)
Table of Contents
Advertisement
Quick Links
Installation and Operating Instructions
ZERO CLEARANCE FIREPLACE
ZERO CLEARANCE FIREPLACE-600
ZERO CLEARANCE FIREPLACE-700
Save this manual and keep it in a safe place that it is easy to refer to it.
The Spartherm Zero Clearnace fireplaces have been tested and certified by CSA based on thefollowing standards:
UL 127 / ULC S610. EPA : U.S.ENVIRONMENTAL PROTECTION
AGENCY Certified to comply with 2020 emissionstandards using cord wood.
1
Spartherm Feuerungstechnik GmbH
Maschweg 38 · 49324 Melle
Phone +49 5422 94 41-0
Fax +49 5422 9441-14
www.spartherm.com
Advertisement
Table of Contents
Related Manuals for Spartherm ZERO CLEARANCE FIREPLACE
Summary of Contents for Spartherm ZERO CLEARANCE FIREPLACE
- Page 1 Installation and Operating Instructions ZERO CLEARANCE FIREPLACE The Spartherm Zero Clearnace fireplaces have been tested and certified by CSA based on thefollowing standards: UL 127 / ULC S610. EPA : U.S.ENVIRONMENTAL PROTECTION AGENCY Certified to comply with 2020 emissionstandards using cord wood.
-
Page 2: Table Of Contents
5” 127mm diameter When using your wood burning appliance, follow these render the heater ineffective and cause smoke. place-600 1.67 g/hr Zero clearance fireplace-700 pipe. Failure to provide this may starve other fuel guidelines for safe operation:... - Page 3 ZERO CLEARANCE FIREPLACE-700 : The Spartherm zero clearance fireplaces have been away to avoid burns or clothing ignition. As with all plastic bags, these are not toys and tested and certified by CSA based on the following •...
- Page 4 Particulate emission standards using cord wood Particulate emission standards using cord wood Particulate emission standards using cord wood Model: Spartherm Cassette 600 Zero Clearance Model: Spartherm Cassette 600 Zero Clearance Model: Spartherm Cassette 700 Zero Clearance Model: Spartherm Cassette 700 Zero Clearance...
- Page 5 2.3 SPECIFICATION 2.6 AIR SYSTEM 2.6.1 CONNECTION DIRECTLY TO THE UNIT moisture in the steel and refractory bricks. The ini- Expansion / contraction noises during heating up and tial heat output will be reduced while the moisture cooling down cycles are normal and to be expected. The ZC Fireplaces-600/700 do require a combustion air outside connection.
- Page 6 3.1.1 PLACEMENT FROM COMBUSTIBLE MATERIALS CLOSURE VALVE 3. INSTALLATION PLANNING 3.1 MINIMUM CLEARANCES TO 1 5/8“ SPACER AT THE BACK PLEASE NOTE: COMBUSTION AIR INTAKE REQUIREMENTS. PLEASE NOTE- 1/2” SPACERS ON THE SIDES AND 1 Distance to furniture 1 5/8“ SPACER AT THE BACK COMBUSTIBLES 5/8”...
- Page 7 3.1.2 PLACEMENT FROM COMBUSTIBLE MATERIALS 3.2 FLANGES AND ANCHOR PLATE ZC FIREPLACE-600 ZC FIREPLACE-700 NOTE! The anchor plate is not included with the unit. Use only an chimney certified as UL 103HT or ULC 25 9/16” / 649mm 29 5/8”/ 752mm S-629.
- Page 8 4. INSTALLATION The hearth requirements are summed up in the following table: 4.1 HEARTH EXTENSION MANTLE MINIMUM CLEARANCES Floor protection reqiurements zero clearance fireplace 600 zero clearance fireplace 700 Distance from top of glass to mantle 21” WARNING 9 1/4”or4 1/2” -WITH 9 1/4”...
-
Page 9: Chimney Installations
4.3 CHIMNEY INSTALLATION • All chimney installations must include at least one The table below shows the minimum height requirements, fireplace included, according to the number of elbows: 2. From below, install a firestop supplied by the chimney manufacturer in each ceiling/floor separation through support. -
Page 10: Examples Of Typical Installations
4.3.4 EX AMPLES OF TYPICAL INSTALLATIONS rain cap storm collar rain cap flashing storm collar attic attic radiation shield flashing attic attic radiation shield elbow 1st floor chimney section radiation shield 1st floor radiant shield chimney section wall radiation shield fireplace elbow basement... - Page 11 ADJUSTING THE COMBUSTION AIR. air. PLEASE USE THE GLOVE THAT IS SUPPLIED WHEN into the combustion chamber. The flames, however, are Spartherm Inserts are equipped with an air con- WARNING!!! FIRE UNATTENDED WHEN THE DOOR IS UNLATCHED OPERATING THE INSERT! more efficient.
-
Page 12: Fire Extinguishers/Smoke Detectors
6.1 FIRE EXTINGUISHERS / SMOKE 6.3 LIGHTING A FIRE 6.3.1 FLASH FIRE 6.3.3 SMOKING backside of the firebox or, if not present, to 50% of the Firewood should be split, stacked in a manner that air affect the extraction of flue gases from the wood the wood pyre to help start the fire. -
Page 13: Ash Removal Procedures
• Replace worn, dried out (inflexible) gaskets. if needed, preferably by a qualified chimney sweep and / or blemishes may result. Normally a hot fire All Spartherm inserts are supplied with Robax glass Description of part • Have chimney regularly cleaned. -
Page 14: Exploded View
This quality manufactured product is state of the art. terms and conditions and undertakings. We particu- The materials used were meticulously selected and If such proof is not produced Spartherm Feuerung- larly advise you to have your wood insert/ are constantly checked, as is our entire production stechnik GmbH shall not be obliged to honour the stove serviced regularly by a stove fitter. - Page 15 10.6 FOR YOUR INFORMATION 10.6 FOR YOUR INFORMATION...
- Page 16 11. SERVICE HISTORY 10.6 FOR YOUR INFORMATION Appliance Service History This heater must be serviced annually depending on usage. Date Dealer Name Service Technician Name Service Performed Special Concerns...
- Page 17 SPARTHERM THE GLOBAL BRAND FOR YOUR LIVING ROOM Your specialist dealer Spartherm Feuerungstechnik GmbH · Maschweg 38 · 49324 Melle Phone +49 5422 94 41-0 · Fax +49 5422 9441-14 · www.spartherm.com...