Table of Contents
Advertisement
SENSORS
Cleaning the Cyclone Sensor
1.
Remove the Rain Funnel by firmly twisting
the funnel counter-clockwise and lifting up.
3.
After cleaning, re-install the Rain Funnel by
placing it back into the sensor and twisting
clockwise until secure.
Tip:
Remove the Cyclone Sensor's batteries before cleaning to avoid accidental rain readings.
2.
Clear any leaves, insects, or other debris to
allow the Rain Tipper to rock freely. Check
and clear the Drainage Holes located on
the underside of the sensor.
4.
You should feel the funnel lock into place
when one of the arrows lines up with the
center of the Lock/Unlock Line.
19
Advertisement
Table of Contents
