Table of Contents
Advertisement
BASICS
Initial Setup
Thermo-Hygro Sensor
Bottom of Cyclone Sensor
Back of Weather Station
(TX141TH-Bv4)
(TX145WSDR)
(328-1415)
Power Jack
Power Up
Thermo-Hygro Sensor:
Install 2 fresh "AA" batteries according to polarity and replace battery cover.
The red LED light will flash when transmitting.
Cyclone Sensor:
Install 3 fresh "AA" batteries according to polarity and replace battery cover.
Weather Station:
Insert the 5V Power Adapter into an outlet, and then plug it into the Power Jack
on the back of the station. Next, remove the Insulation Tab from the Station's Battery Compartment.
About 30 seconds after powering the station on, it will automatically enter the Settings Menu.
See the next page for more details.
Note:
It may take up to 10 minutes for the sensor data to appear on your station's screen.
3
Advertisement
Table of Contents
