Table of Contents
Advertisement
TX141TH-Bv4:
• Insert a mounting screw through the hole at the top to securely mount the sensor.
It can also hang from the back using a nail.
• Mount the sensor vertically in a protected well-shaded area. Keeping it out of direct
weather elements such as sunlight, rain, snow, etc. will help avoid inaccurate
readings.
• For additional protection against weather elements, a Sensor Weather Shield:
https://bit.ly/weather-shield can be purchased separately.
• The maximum wireless transmission range to the station is up to 330ft (100m) in open air. This
does not include walls, floors, or other large obstructions.
• For online video instruction visit: bit.ly/th_sensor_mounting.
Your station is designed for flexible placement on a desk or countertop, or to position on the
wall. When the stand is closed, it provides wall mounting holes.
•
Position within reach of an outlet that is always active. Some of the outlets in living rooms
and bedrooms may only be active when the light switch is on.
•
This station must operate with a 5-volt power cord for a constant backlight.
•
The best sensor reception occurs when only one wall is between your station and each
sensor outside.
•
Position your station six feet from other electronics and wireless devices. If you suspect RF
(radio frequency) interference, simply move your weather station a few feet in any direction.
The Atomic Time Signal originates in Ft. Collins Colorado and has a range of 2000 miles. In
•
some cases, the signal is affected by weather conditions, geographic location. dwelling
construction materials or electrical interferences. The position of the station in the home may
result in poor reception. If the station has not synchronized to the correct time within a few
days of activation, you may need to move the station to a different location. It is best to
position the station near an exterior wall that faces toward Colorado.
HOW DO I CLEAN MY CYCLONE SENSOR?
Tip: To avoid erroneous rain readings while cleaning, you may choose to remove the batteries.
This will cause a loss of Wind and Rain readings during the cleaning process. After cleaning
insert the batteries again and hold the Wind, then the Rain buttons on your station to reconnect.
1. Remove the Rain Funnel by firmly twisting counterclockwise to unlock it. Then lift off.
2. Clear debris from the Rain Tipper inside the sensor. Clear any leaves, dirt, or insects that
may prevent the Rain Tipper from moving freely.
3. After cleaning, re-install the Rain Funnel. Place the Funnel into the sensor and twist
clockwise to attach.
4. Lock the Rain funnel in place. Ensure one of the Arrows on the Rain Funnel aligns with the
Lock Symbol located on the top of the sensor.
WHERE DO I PLACE MY STATION?
6 |
P a g e
Advertisement
Table of Contents
