Panasonic Palmcorder PalmSight PV-L50 Operating Instructions Manual page 31

Playing Back Recordings
TV Playback or Viewing
Connect Camcorder to a TV to view
playback or recordings in progress.
C
TV with AUDIO/VIDEO IN Jacks.
Before you begin...
* Connect Camcorder to power source.
• Make all TV-Camcorder connections.
To Audio In J I To Video In
Audio/Video
Cable
(Supplied)
Set POWER to:
VCR —► view playback.
CAMERA -*■ view picture as it is
recorded.
Turn TV ON and set to LINE
INPUT.
See TV owner's manual.
Begin playback or recording.
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
To Audio/
Video Out
If TV has no VIDEO/AUDIO IN jacks,
connect PV-RF16 RF Adaptor
(optional). Tune TV to CH 3 or 4 to
match RF Adaptor CH 3/4 Selector.
Set Adaptor's TV/VCR Selector to
VCR for playback.
RF Adaptor
CH 3/4 Selector
TV/VCR
Selector
VHF Connecting
Cable
VHF Antenna
300 ohm-75 ohm
transformer
or F Connector
UHF Antenna
Back of TV
To watch TV only,
a
Set Camcorder POWER to OFF.
b
Set RF Adaptor TV/VCR Selector to TV.
C Turn TV ON and select channel.
To VHF Antenna
Terminal
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical Code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
31