Panasonic Palmcorder PalmSight PV-L50 Operating Instructions Manual page 12

Supplying Power
Using the Battery Pack
A fully charged Battery provides a maximum of about 1 hour 10 minutes of continuous
use (LCD monitor off) or about 55 minutes (LCD monitor on). Actual time may vary due to
operating conditions. Using the Built-in Light decreases operating time.
1
2
Attach Battery
© Align Battery with top of mounting
surface.
0 Press and snap into place.
Remove Battery
While sliding
BATTERY RELEASE,
remove Battery.
Battery Refresh
This feature completely discharges Battery before recharging begins.
Use after about every 5 charges for optimum Battery performance.
1
1
2
3
4
Plug in AC Adaptor.
• POWER Lamp stays on as long as
Adaptor is plugged in.
Place Battery into Adaptor.
Press BATTERY REFRESH.
The CHARGE Lamp flashes during
discharge then stays lit until charging
is complete.
If
BATTERY REFRESH is pressed
by mistake, remove Battery from
Adaptor and reinsert it for normal
charging.
Remove Battery.
• Charging takes about 5 hours when
Battery Refresh is used.
• Battery will not operate in extremely high
temperatures.
12
For assistance, please call : 1-800-211-PANA(7262)
or send e-mail to : consumerproducts@panasonic.com