Panasonic Palmcorder PalmSight PV-L50 Operating Instructions Manual page 27

Camera Recording
Programmed Recording
Set a recording start and stop time. Or, set
a 5 or 10 second interval recording to be
done each minute.
Before you begin...
• Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
• Insert cassette with record tab (page 15).
• Set POWER to CAMERA.
p 10M1N. -*■ 20MIN. — 30M1N. —TO TAPE END
INTERVAL * 2 INTERVAL *
10 SEC/MIN. 5 SEC/MIN.
*1 Interval 5 SEC/MIN:
Record 5 seconds each minute.
*2 IntervaMO SEC/MIN:
Record 10 seconds each minute.
Note:
• Start time may not be set over 24 hours
from current time.
• Camcorder shuts off at tape end, or 12
hours after Interval Recording starts.
• To cancel, set POWER to OFF.
1
2
3
Press MENU for MENU mode.
Press UP A or DOWN ▼ to select
PROGRAMMED
im
--■MENU--- PAGE 1/2
aagamsiaaga
TITLE ; AUTO/MANUAL
TALLY LAMP ; ON
STAND-BY RELEASE : OFF
CLOCK SET
Y
SELECT: PUSH Y/A KEY
SET : PUSH DISPLAY KEY
END : PUSH MENU KEY
Press DISPLAY. (Current time is
displayed.)
Each additional press of DISPLAY
increases start
time by 30
minutes.
EH333
REC TIME
SELECT
SET
START
CANCEL
PUSH Y/AKEY
PUSH DISPLAY KEY
PUSH RECORD KEY
PUSH MENU KEY
Press DOWN Y to select
fllM=l. Press DISPLAY repeatedly to
select one of the options shown at
the left.
START
SELECT: PUSH Y/AKEY
SET : PUSH DISPLAY KEY
START : PUSH RECORO KEY
CANCEL PUSH MENU KEY
To cancel the setup, press MENU
twice.
Press RECORD/PAUSE to place
Camcorder in stand-by mode.
—
STAND-BY
START; 10:20PM
REC TIME; 10M1N,
tD20i)0PM
JUN 1 2000
v
Recording will be done as scheduled.
27