Bowflex Max Trainer SE Service Manual page 34

3. Remove the Cap from the hardware that secures
the Leg Assembly.
4. Using a 14mm open faced wrench, remove the
hardware that attaches the Leg Assembly. Remove
the Leg Assembly from the Frame Assembly.
5. Using a Short #2 Phillips screwdriver, remove
the 5 screws (indicated by ovals) that secure the
Decorative Shroud to the Structural Shroud.
Note: The upper screw is slightly under the Structural
Shroud.
34
Cap
Decorative
Shroud
(outer)
Structural
Shroud
(inner)