Console Setup Mode - Bowflex Max Trainer SE Service Manual

Console Setup Mode

Console Setup Mode – System Menu
The Console Setup Mode allows you to set units of measurement to either Imperial or metric, adjust screen brightness, view
maintenance statistics (such as Run Time hours and software version – for service technician use only), or reset the Console.
1. Push the Enter/Start button and hold for 3 seconds while in the Power-Up Mode to go into the Console Setup Mode (System Menu).
Note: Push the Pause/Stop button to save and exit the System Menu and return to the Power-Up Mode screen. The Console will
display "Settings Saved" before exiting to the System Menu.
2. The Console display shows the System Units prompt with the current setting. The default setting is Imperial English units. Push the
Increase/Decrease buttons to change between Imperial (MI/LB) and metric (KM/KG).
Note: If the units change when there is data in User Statistics, the statistics convert to the new units.
3. Push the Enter/Start button to set the selection and continue to the next menu option.
Note: To save the selection and exit the System Menu, push the Pause/Stop button.
4. The Console display shows the Screen Brightness prompt with the current setting. The levels of brightness are: 5 (100%), 4 (80%,
default), 3 (65%), 2 (50%), 1 (35%). The display shows the brightness of the selected level. Push the Increase/Decrease buttons to
move to the desired level.
5. Push the Enter/Start button to set the selection and continue to the next menu option.
6. The Console display shows the Audio Volume prompt with the current setting for the Console beeps. The volume levels are: Off, Low,
Medium (default), High. Push the Increase/Decrease buttons to move to the desired level. It does not affect the output from your
personal device.
7. Push the Enter/Start button to set the selection and continue to the next menu option.
8. The Console display shows the Disconnect Bluetooth prompt. The default option is NO. The YES option will disconnect all Bluetooth®
devices. Push the Increase/Decrease buttons to change between options (YES/NO).
9. Push the Enter/Start button to set the selection and continue to the next menu option.
10. The Console display shows the Auto Connect HR (Heart Rate) prompt. The default option is YES. Push the Increase/Decrease
buttons to change between options (YES/NO).
11. Push the Enter/Start button to set the selection and continue to the next menu option.
12. The Console display shows the Display Metrics prompt. The default option is NO. Push the Increase/Decrease buttons to enable/
disable the display of metrics when connected to the JRNY™ app.
13. Push the Enter/Start button to continue to the next menu option.
14. The Console display shows the Hardware Variant & Console Firmware Version.
15. Push the Enter/Start button to continue to the next menu option.
16. The Console display shows the Base Serial Number.
17. Push the Enter/Start button to continue to the next menu option.
18. The Console display shows the Hardware Variant (machine type).
19. Push the Enter/Start button to set the selection and continue to the next menu option.
20. The Console display shows the Run Time hours (total number of hours of workout time).
21. Push the Enter/Start button to continue to the next menu option.
22. The Console display shows the BLE Version.
23. Push the Enter/Start button to continue to the next menu option.
24. The Console display shows the EX SNSR Version.
25. Push the Enter/Start button to continue to the next menu option.
26. The Console display shows the Error Log prompt (for service technician use only). Push the Decrease button to see the saved errors.
At the end of the errors, the Console display shows the Clear Errors prompt. Push PAUSE/STOP to clear the log. If cleared, the
Console will exit the Console Setup Mode.
9