Table of Contents
Advertisement
| Installation
AN CAUTION
To avoid accidents
+ Install the RS-A1/RS-A2 amplifier in the lug-
° install tapping screws in such a way that the
gage compartment.
screw tip does not touch any lead. This is
Do not install in:
important to prevent leads from being cut by
— Places where it could injure the driver or
vibration of the car, which can result in fire.
passengers if the vehicle stops suddenly.
+ To prevent electric shock, do not install the
~— Places where it may interfere with the dri-
amplifier to places where it might get in con-
ver, such as on the floor in front of the dri-
tact with liquids.
ver's seat.
+ To ensure proper installation, use the sup-
+ Make sure that leads are not caught in the
plied parts in the manner specified. If any
sliding mechanism of the seats, resulting in a
parts other than the supplied ones are used,
short-circuit.
they may damage internal parts of the ampli-
+ Confirm that no parts are behind the panel
fier, or they may become loose and the
when drilling a hole for installation of the
amplifier may come off.
amplifier. Protect all cables and important
equipment such as fuel pipes, brake pipes
and power supply harness from damage.
@
To prevent malfunction
i
+ To ensure proper heat dissipation of the
+ Do not install the amplifier on unstable
i
amplifier, take care of the following during
places such as the spare tire board.
installation.
— Allow adequate space on and around the
amplifier for proper ventilation.
Particularly, do not block the diffuser of
the cooling fan located on the top of the
amplifier.
— Do not cover the amplifier with a floor
!
mat or carpet.
!
€) Before installing and securing:
> Make temporary connections first and check that
> After installing the amplifier, confirm that the spare
the amplifier and the system operate properly. if
tire, jack and tools can be taken out smoothly.
the amplifier or the system does not operate, see
"Troubleshooting" {page 25) to check for incorrect
connections.
Advertisement
Table of Contents
