Advertisement
Installation
14
Install the amplifier where it will not get in the way of driving,
and will not be a danger to passengers during an emergency
stop.
if the amplifier is installed in the passenger compartment, fix it
securely, otherwise it may break free while the car is moving,
and cause an injury or an accident.
Do not install the amplifier anywhere that can get wet, otherwise
it may give an electric shock if touched.
To prevent a short circuit, disconnect the negative battery lead
before beginning installation. After installation has been
completed and checked, reinstall any components that were.
moved or removed, then reconnect the lead to the negative -
battery terminal.
Before drilling any mounting holes, check behind where you want
to make the hole to make sure you do not drill into anything, such
as the gas line, brake lines, electrical wiring, etc.
If installed under a front seat, make sure the amplifier does not
obstruct seat movement. Route all leads and cords carefully so
the sliding seat mechanism does not pinch them and cause a short
circuit.
Do not install the amplifier under the carpet or a floor mat, as this
will impede air circulation, causing the amplifier to overheat and
possibly fail.
Do not install the amplifier near the heater outlet, otherwise it may
overheat and fail.
Use only the parts supplied, and install the amplifier securely. If
parts other than those supplied (specified) are used, they may
come loose or cause damage to internal parts of the amplifier.
Consult your dealer before making any holes in the car.
Screw holes (4-mm-diameter)}
for end cap
Advertisement
