To Prevent Damage - Pioneer ODR PREMIER RS-A1 Owner's Manual

@ To prevent damage
+ Do not use the Digital Fiber Optic Cable CD-
D6C and CD-D15 when using more than four
optical cables in the entire ODR System.
Otherwise no sound may be output.
+ When disconnecting a connector, pull the
connector itself. Do not pull the lead itself, as
it may come away from the connector.
+ Do not ground the speaker lead directly to
the vehicle body. Do not connect multiple
negative (-) speaker leads to a single termi-
nal. Doing so may result in no sound from
the speakers. increasing the sound volume in
this state may blow the fuse of the amplifier.
+ Speakers to be connected to the RS-A1/RS-A2 amplifier should conform with
the standards listed below. Otherwise damage will be caused to the speaker.
Speaker
H T
Channel | Type pimpadance
Subwoofer Nominal input: Min. 15 W
2-channel = + —
Other than subwoofer Max. input: Min. 30 W
RS-Al 1-8Q
Subwoofer Nominal input: Min. 60 W
1-channel
Other than subwoofer Max. input: Min. 60 W
Subwoofer Nominal input: Min. 50 W
2-channel
Other than subwoofer Max, input: Min. 100 W
RS-A2 2~82
Subwoofer Nominal input: Min. 160 W |
1-channel {
Other than subwoofer Max. input: Min. 200 W
To ensure grounding
> To ensure connection of the ground lead, remove
paint with sandpaper if it must be connected to a
painted portion.
To prevent noise
> Install and route the special red battery lead sup-
plied with the amplifier as faraway as possible from
the IP-BUS and speaker leads. install and route the
battery lead, ground lead, IP-BUS and speaker
leads, and the RS-A1/RS-A2 amplifier as faraway as
possible from the antenna, antenna cable and
tuner,
Connection of the IP-BUS and optical dig-
ital line
> To prevent incorrect connection, the input side of
the IP-BUS and optical digital line connector is col-
ored in blue, and the output side in black. Connect
the connectors of the same colors correctly. (The
portions to be connected of the IP-BUS connector
are colored.)
When AM broadcasts produce beat noise
> Change the BFC switch which is located at the bot-
tom of the amplifier between L and H.
BFC switch