Pioneer ODR PREMIER RS-A1 Owner's Manual page 13

| Connecting the Cnits
AN CAUTION
To prevent short-circuit
+ Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap adhe-
sive tape around them where they lie against
metal parts.
Do not route wires where they will get hot,
for example where the heater will blow over
them. If the insulation heats up, it may
become damaged, resulting in a short-circuit
through the vehicle body.
Make sure that wires will not foul moving
parts of the vehicle, such as the gearshift,
handbrake or seat sliding mechanism.
AN CAUTION
To avoid accidents
+ Do not shorten any leads. Otherwise the
protection circuit may fail to work when it
should.
+ Never feed power to other equipment by
cutting the insulation of the power supply
lead to tap from the lead. The current capaci-
ty of the lead will be exceeded, causing over-
heating.
Be sure to use the special red battery lead
supplied with the amplifier and connect
directly to the battery. Use the supplied
black ground lead and connect to the vehicle
body. (The supplied special red battery and
ground leads are designed so that the ampli-
fier can be connected safely.)
@ To prevent overload to the battery
* The power consumption of the RS-A1 is very
high. To avoid overload to the battery, do
not connect more than two RS-A1 amplifiers
to an ODR System.
16