Table of Contents
Advertisement
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send and receive information from
the vehicle. The Control Module transmits confirmation signals from the vehicle to
your pager. Your range will vary depending on location, terrain, and local RF
noise/interference. This system is not guaranteed to page you if you are behind
concrete walls, underground, in a large structure, or in an area with high levels of
electronic interference. Handle the pager/remote with care. For more on range,
see "Range Questions" on page 18.
OPERATION:
Button
Functions
Lock Doors & Arm System
Unlock
Doors
System
Trunk Release (Aux # 1)
Aux #2
Start or Stop engine
2-car operation (Side Button)
(Change from Car 1 to Car
2)
Side Button
2-WAY LED PAGING REMOTE
Button Options
Press
and
Hold
seconds
Activate "Panic" feature
&
Disarm
Press twice for second door
unlock
Press and Release for Aux
#1
Press and Hold Button #2
and #3 at the same time for
3 seconds. (Aux #2)
Press and Hold
seconds
Press and hold for 5 seconds to switch to vehicle #2
Press and release to show the previous status.
VEHICLE
Buttons
for
3
for 3
.
3
#1
#5
LOCK
2nd
#3
TRUNK
POP
Functions
Button Options
Aux#3
Press Button #1 and #4 at the
same time
Aux #4
Press Button #3 and #4 at the
same time.
Car Jack
Press and Hold Button #1 and #3
(See page 14)
at the same time for 2 seconds.
Silent
Press Button #2 and #4 at the
Arm/Disarm
same time.
Press within 3 seconds of arming to disable
Sensor Disable
sensor input
Valet mode
When Disarmed Press and Hold for 3
seconds to go into Valet mode. Release,
press and hold again for 3 sec. to enter
Valet Park.
#2
UNLOCK
#4
ENGINE
START
Advertisement
Table of Contents
