Transmitter Programming - CrimeStopper Super Rage CS-2012DPII-TW1 Operating Instructions Manual

2-way fm/fm paging remote alarm, keyless entry system & engine starting system with 1-way sidekick remote control

Table of Contents

Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or

adding remotes, ALL your system's remote codes must be learned at time of programming!! This

system allows storage of up to 4 different remote codes in memory.

1. Turn key to the ON position. (Starting the vehicle is not necessary.)

2. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.

3. Press Button #1 (Lock) & #2 (Unlock) button [at the same time] of the transmitter to be learned. You should

get 2 light flashes indicating the code-learn. Press the Lock and Unlock Buttons on a second, third or

fourth remote. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn

key OFF and close the hood.

NOTES: When learning pager remotes, wait for a beep confirmation tone from the remote before learning

another remote. When learning 1-way "Sidekick" remotes, you do not have to wait. The system will not flash

the lights after learning the 4th remote code.

IGN

OFF

2-WAY REMOTES

LOCK &

UNLOCK

PRESS TOGETHER