Table of Contents
Advertisement
Correcting the date
1. Depress the Select button © to make a different
category of digits on the LCD panel you want to
change blink.
2. Depress the Adjust button © to change digits of the
specified category you chose with the Select button
©. Digits increase by one each time you depress the
Adjust button
0
.
Holding down the button will
advance digits continuously.
• The blinking
allows precise fine-tuning of the
internal clock to the beginning of a specified minute.
To do so, depress the Select button © to make the
blink, and then depress the Adjust button
0
in sync
with a time signal.
3. After the data has been adjusted, depress the Select
button. The bar mark (-) appears on the LCD panel,
indicating that data imprinting choices are possible.
• If you release the shutter while the blinking data is
being corrected, the data cannot be imprinted.
• Numerical indication
Year
=87-19(1987-2019)
Month = 1-12
Day
=1-31
Time
= 0-23
Minute = 00-59
OPERATIONAL PRECAUTIONS
The data on the LCD panel is imprinted on each frame
you expose.
• "Year-Month-Day" and "Day-Hour-Minute" can¬
not be imprinted at the same time.
• As you release the shutter, the bar (-) mark on the
display blinks for a few seconds, indicating the data
has been imprinted.
• If there is a white or yellow object in the comer ot the
picture where the data is imprinted, the data may be
difficult to read.
When
composing your photo¬
graphs, try to avoid brightly-colored subjects in that
comer.
35
Advertisement
Table of Contents
