Option Programming; Programmable Options - CrimeStopper CS-2002DC Series II Installation And Operating Instructions Manual

PROGRAMMABLE OPTIONS

1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear a long confirmation chirp.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren will chirp for each button press. DO NOT LOSE COUNT!!
3. When you get to the desired option number, press the appropriate button on the transmitter according to the chart
below. Turn Ignition off. See Below for Option numbers, descriptions, and values. (Button 1 gives a single light
flash/chirp, Button 2 gives two light flashes/chirps, and Button 3 gives three light flashes/chirps.)
4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options, check
operation to see if the option(s) have changed.
Option # Option Description
1. Factory Horn Chirps / Pulses
2. Passive Arming /
Passive Chirp Countdown
3. Passive Lock / Cust. Override
4. Ignition controlled Locks
5. 10/60 Sec. Door Open
Warning
6. Active Re-Arm
7. Double Unlock Pulse
8. Silent Arm/Disarm
(Chirp Defeat)
9. Parking Lights on with disarm
10. Disarm with trunk pop
11. Silent Arm/Disarm with
Remote (Button 3)
12. Door Lock Pulse Time
13. Type of Carjack Protection
14. Carjack Enable/Disable
15 Allow Arming & Disarming
With Ignition ON

OPTION PROGRAMMING

PROGRAMMING OPTIONS CHART
BUTTON 1 BUTTON 2
LOCK UNLOCK
Pulse with Arm/Disarm Chirps
trip only & Pulse with trip
ON OFF*
ON OFF*
ON* OFF
10 Sec. 60 Sec.*
ON* OFF
1 pulse* 2 pulses
Chirps* No Chirps
YES* NO
NO YES*
YES* NO
0.7 Sec.* 3 Sec.
ACTIVE* PASSIVE
DISABLED* ENABLE
ENABLE *DISABLED
* = Default
BUTTON 3
TRUNK
Arm/Disarm/Warn Chirp
& Pulse with trip *
Chirp Countdown
Custom Override
Ignition Lock Only
FULL-TIME