Option Programming - CrimeStopper CS-2000.III Installation And Operating Instructions Manual

Series iii remote control alarm system

Hide thumbs

Table Of Contents

Table of Contents

1. Turn the Ignition ON and press the Override/Program button 5 times. After a slight delay, the system will flash the

lights 5 times.

2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to

the feature list below. The siren will chirp for each button press. DO NOT LOSE COUNT!!

3. When you get to the desired option number, press the appropriate button on the transmitter according to the chart

below. Turn Ignition off. See Below for Option numbers, descriptions, and values. (Button 1 gives a single light

flash/chirp, Button 2 gives two light flashes/chirps, and Buttons (1+2) together gives three light flashes/chirps.)

4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options, check

operation to see if the option(s) have changed.

PROGRAMMING OPTIONS CHART

Option #

Option Description

Factory Horn Chirps / Pulses

Passive Arming /

Passive Chirp Countdown

Passive Lock

Ignition controlled Locks

10/60 Sec. Door Open Warning

Active Re-Arm

Double Unlock Pulse

Silent Arm/Disarm

(Chirp Defeat w/Button 1)

Parking Lights on with disarm

10.

Disarm with trunk pop

11.

Silent Arm/Disarm with Remote

(Button #2)

12.

Door Lock Pulse Time

13.

Type of Carjack Protection

14.

Carjack Features Enable/Disable

15.

L/UL or Arm/Disarm w/IGN ON

NOTE: Options can be instantly restored to Factory Default Values: To restore default values: Perform step #1 above,

then press buttons (1+2) together. The siren will chirp 4 times and lights will flash 4 times. Turn OFF Ignition. All

programming options should be restored to "*" values (See chart above).