Transmitter Programming - CrimeStopper CS-2002DC Series II Installation And Operating Instructions Manual

This system will learn a maximum of 3 transmitters total.
1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3
chirps.
2. Press the Program/Override Button 5 times and you should hear 5 light flashes and 5 siren chirps.
3. Press #1 (LOCK) on the transmitter two times:
a. First press gives 1-siren chirp
b. Second press, gives 2-siren chirps (Code learn confirmation)
4. Repeat steps a. & b. above for up to 2 additional transmitters, or turn Ignition OFF. Siren will chirp 3 times and lights
will flash 3 times when exiting transmitter programming mode.
Note 1: If you are using this identical alarm system in two vehicles, you can program button 4 (PANIC) from the
OTHER vehicle's remote to Arm/Disarm THIS alarm system. Follow steps above, but press the OTHER vehicle's
remote Button #4 (PANIC) 2 times in step 3. The other vehicle's remote transmitter will only ARM/DISARM with Button
4 and not perform any auxiliary or special features on THIS system.
Note 2: Previous software versions follow the same steps above with one exception: You are only required to press
the lock button ONCE at step #3 on older software systems. New Transmitters will work on previous versions but old
transmitters will not work on the latest version. Current transmitters and control modules will be identified with a
GREEN dot.
DIAGRAM:
OFF
PRESS LOCK
BUTTON 2 X's

TRANSMITTER PROGRAMMING

TURN IGN. ON
IGN
3 TIMES:
ON, OFF
ON, OFF
ON.
1st = 1 CHIRP
PANIC
2nd = 2 CHIRPS
(CODE LEARNED)
rd
time. (ON/OFF, ON/OFF, ON) You should hear (3)
5 CHIRPS
PRESS
BUTTON
5 TIMES
5 FLASHES
LEARN
OR
ANOTHER
REMOTE
IGN
OFF
3 CHIRPS