Table of Contents
Advertisement
Symptom
Transferring
to a USB device
results
ill all error.
Audio files or lk)lders on the
USB device cannot be erased.
Problems
and solutions
• The USB device
was disconnected
or the power was turned off during erasing.
Delete the partially-erased
file. If this does not fix the problem,
the USB device
may be broken. Follow the procedure
in the operating
instructions
of the [JSB
device to format the USB device.
If the problem persists,
contact
your nearest
Sony dealer.
• Check if the [JSB device is write-protected.
Tuner
Symptom
Problems
and solutions
Radio stations
cannot be tuned
• Check that the antenna
(aerial)
is connected
securely.
Adjust the antenna
in.
(aerial) or connect
an external
antenna
(aerial) if necessary.
• The signal strength
of the stations
is too weak (when tuning in with automatic
tuning). [Jse direct tuning.
FM reception
is poor.
• Use a 75-ohm coaxial
cable (not supplied)
to connect
the unit to an outdoor
FM
antenna
(aerial).
Control
for HDMI
Symptom
The Control for HDMI function
does not work.
No sound is output from the
system
and TV while using the
System
Audio Control
function.
Messages
Problems
and solutions
• Set [CONTROL
FOR HDMI]
in IHDMI SETUP]
to [ON] (page 56).
• Make sure that the connected
component
is compatible
with the [CONTROL
FOR HDMI]
function.
• Check the connected
component's
setting for the Control
for HDMI function.
Refer to the operating
instructions
of the component.
• If you change the HDMI connection,
connect
and disconnect
the AC power
cord (mains lead), or have a power failure, set [CONTROL
FOR HDMI] in
[HDMI SETUP]
to [OFF], then set to [ON] (page 56).
• For details,
see "Using the Control
lk)r HDMI Function
for "BRAVIA"
Sync"
(page 47).
• Make sure that the connected
TV is compatible
with the System Audio Control
function.
• For details,
see "Using the Control
lk)r HDMI Function
for "BRAVIA"
Sync"
(page 47).
Symptom
"PROTECTOR"
and "PUSH
POWER"
appear alternately.
"OVERLOAD,"
"REMOVE
USB,"
then "PUSH POWER"
appear.
Problems
and solutions
• Press I/_
to turn off the system,
and check the following
items after
"STANDBY"
disappears.
Are the + and
speaker cords short-circuited?
Is anything blocking
the ventilation
holes of the system?
After checking
the above items and fixing any problems,
turn on the system.
If the cause of the problem cannot be found even aher checking
all the above
items, consult
your nearest
Sony dealer.
• A problem
has been detected
with the level of electrical
current from the
(USB) port. Turn off the system
and remove
the [JSB device
from the
(USB) port. Make sure there is no problem with the USB device. If this display
pattern
persists,
contact your nearest Sony dealer.
68u_
Advertisement
Table of Contents
