Sony DAV-DZ 170 Operating Instructions Manual page 27

8 Press (--/-) to select the speaker
formation image as the speakers are
actually positioned, then press @.
SPEAKER FORMATION
9
STANDARD
• [STANDARD]: Select this when you
install all the speakers normally.
• [NO CENTER]: Select this when you
install the front and surround speakers
only.
• [NO SURROUND]: Select this when you
install the center and front speakers only.
• [FRONT ONLY]: Select this when you
install the front speakers only.
• [ALL FRONT]: Select this when you
install all the speakers in front of the
listening position.
• [ALL FRONT - NO CENTER]: Select
this when you install the front and
surround speakers in front of the listening
position.
Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front
panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
Calibration mic
1 0 Press (--1-)to select [YES], then press
®.
Be quiet duriug the measuremeut.
m
• Loud test sounds are output when [AUTO
CALIBRATION] starts. You cannol turn the
volume down. Give consideralion lo children
and neighbors.
• The environment of the room in which the
system is installed may affect measuremenls.
When lhe measuremenls dilfer considerably
from the stalus of Ihe speaker installation,
perform Ihe speaker setlings manually by
lk)llowing "Settings for the speakers" (page 60).
11
Unplug the calibration mic, press (--/e
to select [YES], then press @.
To quit the Quick Setup
Press O DISPLAY iu auy Step.
27us