Table of Contents
Advertisement
Precautions
On power
sources
• Unplug the unit from the wall outlet (mains)
if you do
not intend to use it for an extended
period of time. To
disconuect
the cord, pull it out by the plug, never by
the cord.
On placement
• Place tile system in a location
with adequate
ventilation
to prevent
heat build-up
in the system.
• At high volume,
over long periods of time, the cabinet
becomes
hot to the touch. This is not a malfunction.
However,
touching
the cabinet should be avoided.
Do
not place the system in a confined
space where
ventilation
is poor as this may cause overheating.
• Do not block the ventilation
slots by putting anything
on the system. The system
is equipped
with a high
power amplifier.
If the ventilation
slots are blocked,
the system can overheat
and malfunction.
• Do not place the system on surfaces
(rugs, blankets,
etc.) or near materials
(curtains,
draperies)
that may
block the ventilation
slots.
• Do not install the system
heal heat sources such as
radiators,
or air ducts, or in a place subject to direct
sunlight, excessive
dust, mechanical
vibration,
or
shock.
• Do not install the system in an inclined position.
It is
designed
to be operated
in a horizontal
position
only.
• Keep the system
and discs away from components
with strong magnets,
such as microwave
ovens, or
large loudspeakers.
• Do not place heavy objects on the system.
On operation
• If the system is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense
on the lenses inside the unit. Should
this occur, the system may not operate
properly.
In
this case, remove the disc and leave the system turned
on for about hall' an hour until the moisture
evaporates.
• If anything falls into the cabinet,
unplug the unit and
have it checked
by qualified
personnel
before
operating
it any further.
On adjusting
volume
• Do not turn up tile volume while listening
to a section
with very low level inputs or no audio signals.
If you
do, the speakers
may be damaged
when a peak level
section is suddenly
played.
On cleaning
• Clean the cabinet, panel, and controls with a soft cloth
slightly moistened
with a mild detergent
solution.
Do
not use any type of abrasive pad, scouring
powder or
solvent
such as alcohol or benzine.
If you have any questions
or problems
concerning
your system, please consult
your nearest Sony dealer.
On cleaning
discs, disc/lens
cleaners
• Do not use cleaning
discs or disc/lens
cleaners
(including
wet or spray
types). These may cause
the apparatus
to malfunction.
On your TV's
color
• If tile speakers
should cause your TV screen to have
color irregularity,
turn off' the TV then turn it on after
15 to 30 minutes.
If color irregularity
should persist,
place the speakers
further away from your TV set.
IMPORTANT
NOTICE
Caution:
This system
is capable
of holding a still
vide() image or on-screen
display
image on your
television
screen indefinitely.
If you leave the still
vide() image or on-screen
display
image displayed
on your TV for an extended
period of time you risk
permanent
damage
to your television
screen.
Projection
televisions
are especially
susceptible
to
this.
On moving
the system
• Belbre moving tile system, make sure that there is no
disc inserted,
and remove the AC power cord (mains
lead) from the wall outlet (mains).
62us
Advertisement
Table of Contents
