Sony DAV-DZ 170 Operating Instructions Manual page 57

• [YCBCR/RGB (HDMI)]
You can select the type otHDMI signal output
fi'om the HDMI OUT jack.
[YC_C_d:The system outputs YCBCI_signals.
[RGBI: The system outputs RGB signals.
• [AUDIO (HDMI)]
You can select the audio output status from the
HDMI OUT jack.
[OFFI: The system does not output sound fi'om
the HDMI OUT jack.
[ONI: The system outputs audio signals by
converting Dolby Digital, DTS, or 96 kHz/24-
bit PCM signals to 48 kHz/l 6-bit PCM.
m
• When you set the function to other than "DVD/CD"
or "USB," the system does not output the sound from
the HDMI OUT jack even if you set [AUDIO
(HDMI)] to [ON].
• [JPEG RESOLUTION]
You can select the resolution of JPEG image
files output fiom the HDMI OUT jack.
[SD Ell: The system outputs standard
resolution with a black frame.
[HD IZ]]: The system outputs HD resolution
with a black fiame.
[HD]: The system outputs the HD resolution
without a black fiame.
[(1920 x 1080i) HD lZ]l: The system outputs
lull size HD resolution with a black frame.
[(1920 x 1080i) HD]: The system outputs full
size HD resolution without a black flame.
m
• [JPEG RESOLUTION] is effective only when you
set [TV TYPE[ in [VIDE(-) SETUP] to [16:91, and
you set [HDMI RESOLUTION] in [HDMI SETUP]
to other than [720 x 480p1 or [720 x 480/576p].
• You can select [(1920 x 1080i) HD [ZI] or [(1920 x
1080i) HD] only when you set [HDMI
RESOLUTION] in [HDMI SETUP] to [1920 x
1080i].
• The HDMI signal will stop momentarily when:
the system is loading or unloading a DATA CD or
DATA DVD.
you connect or remove a USB device.
[AUDIO SETUP]
• [SPEAKER FORMATION]
Depending on the shape of the room, you may
not be able to install some speakers. For better
surround sound, Sony recommends that first you
decide the position of the speakers.
1 Press ÷/+ to select a setting, then
press @.
• [STANDARD]: Select this when you
install all the speakers normally.
• [NO CENTER]: Select this when you
install the front and surround speakers
only.
• [NO SURROUND]: Select this when you
install the center and fiont speakers only.
• [FRONT ONLY]: Select this when you
install the front speakers only.
• [ALL FRONTI: Select this when you
install all the speakers in front of the
listening position.
• [ALL FRONT - NO CENTERI: Select
this when you install the fiont and
surround speakers in fiont of the listening
position.
2 Press 1"-/'-) t o select [YES] or [NO], then
press @.
• [YESI: Continue with [AUTO
CALIBRATIONI. Follow the Steps of
[AUTO CALIBRATION1 below.
• [NOI: Exit [SPEAKER FORMATION1.
• [AUTO CALIBRATION]
D. C. A. C. (Digital Cinema Auto Calibration)
can set the appropriate surround sound
automatically.
1
Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front
panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
¢KI
57us