Table of Contents
Advertisement
20 September 1999
Mode No.
Class
Class
1 and 2
3
ADF Registration
(Trailing Edge
Erase)
3
6-006*
ADF Registration
(Side-to-Side/Rear)
4
ADF Sub-scan
Magnification
6-007*
ADF Free Run
6-009
Stamp Position
6-010*
Adjustment
ADF APS Data
Display
6-901
ADF Scanning
Method
6-902*
ARDF Skew
6-905*
Correction
ARDF Original Curl
Adjustment
6-906*
ADF/Printer Free
6-910
Run
Function
Adjusts the trailing edge erase margin in the
ADF mode.
Use the ó key to toggle between + and -
before entering the value. See
"Replacement and Adjustment - Copy
Adjustment" for details.
Adjusts the side-to-side registration on the
rear side of the original in the ADF mode.
Use the ó key to toggle between + and -
before entering the value. See
"Replacement and Adjustment - Copy
Adjustment" for details.
Adjusts the magnification in the sub-scan
direction for ADF mode.
Use the ó key to toggle between + and -
before entering the value. See
"Replacement and Adjustment - Copy
Adjustment" for details.
Performs an ADF free run in duplex
scanning mode.
After selecting "1", press "OK" or the é key
twice then set the paper to start this feature.
Press the E (Clear/Stop) key to stop.
Adjusts the stamp position in the sub-scan
direction in fax mode.
Displays the status of the original size
sensors in the ADF.
See the "DF APS Original Sensor Output
Display" section.
Selects the original scanning method in ADF
mode.
Do not change the setting.
Selects whether the skew correction is done
or not when the ARDF feeds the rear side of
the original.
Adjusts the amount of original buckle at the
ARDF registration roller when the ARDF
feeds the rear side of the original.
This SP mode is only effective when SP 6-
905 is at "1".
This SP is for the designers only do not
perform this SP mode.
4-51
SERVICE PROGRAM MODE
Settings
–3.0 ~ +3.0
0.1 mm/step
-1.0 mm
–7.0 ~ +9.5
0.5 mm/step
0.0 mm
–0.9 ~ +0.9
0.1%/step
0.0%
0: No
1: Yes
–10 ~ +10
1 mm/step
0 mm
0: Doc
(original)
1: Mag
(copy paper
size +
magnificatio
n)
0: No
1: Yes
-20 ~ +20
1 mm/step
0 mm
0: No
1: Yes
Advertisement
Table of Contents
